Product Manual

PERIODICAL MAINTENANCE
19/05/05 76440-GB
I
GB
F
TS 400 PS
TS 500 PS
M
44.1
REV.0-05/05
PROGRAMS
The interventions listed below must be effected at the intervals (hours and months) in the chronologie order
A every day or every 8 hours D every 1000 hours
B every 250 hours or every 6 months E every 2000 hours
C every 500 hours or every 12 months F every 3000 hours
(1) Replace the antifreeze every 2 years. If instead of antifreeze, anticorrosive is used in the coolant, replace it
every 6 months. Make sure you use the right quantity.
(2) By well trained staff.
(3) The interval for changing oil must be modied if the load factor of the engine is above 40% or if a specically
wrong oil is used. If you are not sure how to calculate the load factor for said application, please turn to the
Assistance Centre.
A B C D E F HOW IT WORKS
l
Check the level of the coolant
l
Check the concentration of the coolant (1)
l
Check the tension and the state of the driving belt
l
Replace the control belt of the alternator
l
Drain the water from the prelter (if assembled)
l
Replace the cartridge of the fuel lter
l
Check the efciency of the injectors (2)
l
Check the level of the lubricating oil
l
Change the lubricating oil of the engine (ll slowly, make shure the right quantity is used)
(3)
l
Replace the engine oil lter
l
Clean the air lter and empty the dust gathering cup of the air lter in very dusty condi-
tions
l
Clean the air lter and empty the dust gathering cup of the air lter in very dusty condi-
tions
Clean the housing of the rotor in the turboblower and the housing of the compressor in
the turboblower (2)
l
Check the valve clearance of the engine and set it up if necessary (2)
l
Check all hoses and connectors
l
Replace the engine breather pipe
l
Check the alternator, the starting motor (2)
l
Inspect the electrical plant to see that the wires are well rm and not worm out
l
Check and repair any loss or damage at the engine