C0MP6041ZProduct Card

MADE IN ITALY
language
ENGINE DRIVEN WELDER
CS 230 YSX CC/CV
4 STROKE, DIRECT INJECTION, NATURAL ASPIRATED
Model YANMAR L 100 V
* Stand-By net power 6.3 kWm (8.5 hp)
* PRP net power 5.7 kWm (7.7 hp )
* COP net power /
Cylinders / Displacement 1 / 435 cm³ (0.27 lt.)
Bore / Stroke 86 / 75 (mm)
Compression ratio 20 : 1
BMEP (Brake Mean Eective
Pressure : LTP - PRP)
/
Speed governor type Mechanical
FUEL CONSUMPTION
110 % (Stand-by power) 1.9 lt./h
100 % to PRP 1.7 lt./h
75 % to PRP 1.2 lt./h
50 % to PRP 0.8 lt./h
COOLING SYSTEM
Total system cap. - only engine /
Fan air flow /
LUBRICATION SYSTEM
Total oil system capacity /
Oil capacity in sump 1.6 lt.
Oil consumption at full load /
EXHAUST SYSTEM
Maximum exhaust gas flow /
Max. exhaust gas temp. /
Maximum back pressure 4.3 kPa (0.043 bar 440 mmH₂O)
External diameter exhaust pipe /
ELECTRICAL SYSTEM /
Starter motor power 0.8 kW
Battery charging alternator cap. 15 A
Cold start - 10°C
With cold start aid /
AIR FILTER Dry
Combustion air flow /
HEAT REJECTED AT FULL LOAD
To exhaust system /
To water and oil /
Radiated to room /
To charge cooler /
EnginE 3000 rpm
* Output powers according to ISO 3046-1
air
cooled
diesel electric
sterter
Chopper
System
The images are for reference
WELDING PROCESS
Shielded Metal Arc
welding SMAW
(STICK)
Gas Tungsten Arc
Welding GTAW
(TIG)
Gas Metal Arc
Welding GMAW
(MIG)
Flux Cored Arc
Welding FCAW
(FLUX CORED)
FEATURES
• Arc welding source in D.C. welding
• High frequency control of welding current and voltage
• Engine cowling side, can be completely opened, which
facilitates all maintenance operations
• The recessed control panel is lockable and houses the
sockets and machine
• A.C. generator, single-phase and three-phase
• Aux power also available while welding
• Power optimiser (engine power optimization system)
• VRD - Voltage reduction device
• Large fuel tank (23 l)
• Meets EC directives for noise and safety
E
N
G
I
N
E
S
T
A
G
E
5
pag 1
06/2020
DEFINITIONS
SMAW: Coated electrode welding is an arc welding with protected metal.
GMAW: welding is an arc process with metal under gas protection.
FCAW (FLUX CORED): The process with cored wires is very similar to MIG / MAG welding.
Continuous wire is not full but consists in a metal strip that wraps a powders core (flow).
GTAW: is a welding process that uses a tungsten electrode that cannot melt.