Specifications
4
Mortonr System Saverr Installation & Operation Manual
BEFORE YOU START
FOLLOW THE INSTALLATION INSTRUCTIONS CAREFULLY. FAILURE TO INSTALL THE SOFTENER PROPERLY VOIDS
THE WARRANTY.
BEFORE YOU BEGIN INSTALLATION, READ THIS ENTIRE MANUAL. THEN, OBTAIN ALL THE MATERIALS AND TOOLS
YOU WILL NEED TO MAKE THE INSTALLATION.
CHECK LOCAL PLUMBING AND ELECTRICAL CODES. THE INSTALLATION MUST CONFORM TO THEM. CODES IN
THE STATE OF MASSACHUSETTS REQUIRE INSTALLATION BY A LICENSED PLUMBER. FOR INSTALLATION, USE
PLUMBING CODE 248--CMR OF THE COMMONWEALTH OF MASSACHUSETTS.
USE ONLY LEAD--FREE SOLDER AND FLUX FOR ALL SWEAT--SOLDER CONNECTIONS, AS REQUIRED BY STATE
AND FEDERAL CODES.
USE CARE WHEN HANDLING THE SOFTENE R. DO NOT TURN UPSIDE DOWN, DROP, OR SET ON SHARP P ROTRU-
SIONS.
DO NOT LOCATE THE SOFTENER W HE RE FREEZING TEMPERATURES OCCUR. DO NOT ATTEMPT TO TREAT WA-
TER OVER 120F. FREEZING, OR HOT WATE R DAMAGE VOIDS THE WARRANTY.
AVOID INSTALLING IN DIRECT SUNLIGHT. EXCESSIVE SUN HEAT MAY CAUSE DISTORTION OR OTHER DAMAGE TO
NON--METALLIC PARTS.
THE SOFTENER REQUIRES A MINIMUM WATER FLOW OF 3 GALLONS PER MINUTE AT THE INLET. MAXIMUM AL-
LOWABLE INLET WATER PRESSURE IS 125 P S I. IF DAYTIME PRESSURE IS OVER 80 PSI, NIGHTTIME PRESSURE
MAY EXCEED THE MAXIMUM. USE A PRESSURE REDUCING VALVE IF NECESSARY. ( ADDING A PRESSURE RE-
DUCING VALVE MAY REDUCE THE FLOW.)
THE SOFTENER WORKS ON 24 VOLT, 60 Hz ELECTRICAL P OWER ONLY, SUP PLIED BY A DIRECT PLUG--IN TRANS -
FORMER (INCLUDED). BE SURE TO USE THE INCLUDED TRANSFORMER AND PLUG IT INTO A NOMINAL 120V, 60
CYCLE HOUSEHOLD OUTLET THAT IS GROUNDED AND PROPERLY PROTECTED BY AN OVER CURRENT DEVICE
SUCH AS A CIRCUIT BREAKER OR FUSE. IF TRANSFORMER IS REPLACED, USE ONLY UL, CUL OR CSA APPROVED
CLASS 2 TRANSFORMER WITH THE FOLLOWING SPECIFICATIONS:
-- INPUT: 120 VAC, 60 Hz, 13.5 W
-- OUTPUT VOLTAGE: 24 VAC
-- OUTPUT CURRENT: 400mA
THIS SYSTEM IS NOT INTENDED TO BE USED FOR TREATING WATER THAT IS MICROBIOLOGICALLY UNSAFE OF
OF UNKNOWN QUALITY WITHOUT ADEQUATE DISINFECTION BEFORE OR AFTER THEY SYSTEM.
EUROPEAN DIRECTIVE 2002/96/EC REQUIRES ALL ELECTRICAL AND ELECTRONIC EQUIPMENT TO BE DIS-
POSED OF ACCORDING TO WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE) REQUIREMENTS.
THIS DIRECTIVE OR SIMILAR LAWS ARE IN PLACE NATIONALLY AND CAN VARY F ROM REGION TO REGION.
PLEASE REFER TO YOUR STATE AND LOCAL LAWS FOR PROPER DISPOSAL OF THIS EQUIPMENT.