User Manual

____________________________________________________________________________Section 2
2-13
Sending (Optional) Call Signals
During the patient data transmission session, the patient may be instructed to transmit call signals from the X12+ to
a receiving device for monitoring purposes.
To send a call signal, press any one of the three keys on the X12+. The CALL message is displayed in the Main
Menu on the LCD display to inform the user that a call was sent.
Ending a Transmission Session
At the end of the patient session, the X12+ Transmitter can be turned off by:
1. Opening the battery door and removing the battery, or
2. Pressing and holding the Enter key for approximately three seconds
a. Select the Up/Right arrow key to highlight YES
b. Press the Enter key to Select YES