Instructions

25
1.6 Connecting the ue pipe
The ue collar can be rotated and be used for ø150 (inside and outside the ue collar) and
ø120 connections.
Mounting the ue collar pointing upwards
From the factory, the stove is prepared for installation with a top exit ue collar (1). Take the
bae plates out of the stove to facilitate the installation. The enclosed cast-iron ue collar
is fastened to the top of the stove with the included screws. The ball stop, which prevents
the chimney sweep from damaging the stove’s bae plates while sweeping, is the 160 mm
long rod that is provided in the stove. The ue collar stop bar is tted when installing the
chimney.
Mounting the ue collar to the rear
Take the bae plates out of the stove to facilitate the installation.
Remove the knock out cover from the rear heat shield with easy rm taps of a hammer next
to the small conneting “bridges”. Now remove the cover from the rear convector plate using
the same method. Next, the round cover is unscrewed from the back panel of the stove and
reinstalled in the hole in the top panel. The enclosed cast-iron ue collar is fastened to the
back of the stove with the included screws.
The ball stop is not used when installing with the ue collar to the rear.
Finally, the enclosed cover plate is put in place in the top panel to cover the ue exit hole.
The location of the baes
The baes (2) and (3), which are made from
vermiculite, are mounted on delivery.
Make sure that the baes are correctly as-
sembled before lighting the stove (please
see the sketch).
Fresh air connection, if required
The stove is factory prepared for installation
of an optional extra adaptor (4) for a fresh air
connection underneath the stove. However,
this does not apply to the wall-hung S11-70.
A
A
A-A
1
2
3
4
Revisions
Rev.
Sign.:
Title:
Drawing no.:
1:5
Snit til vejledning
Morsø S11
RSV
2011.08.11
A4
Date of print: 11-09-2012
U:\udv\Tegninger\S11\S11 Fireplace Assembly.SLDASM
S-11-006 a
-
Itemno.:
This drawing is Morsø Jernstøberi A/S' property and must not be sold, lended or copied without any written authorization from the company.
Material:
Weight kg.:
Model no.
Drawingtype:
Location of file:
Scale:
Format:
Released:
Construction:
Date: