Instructions
30
DK ENG
1. We recommend using the “top-down” method to light your
wood-burning stove. It is the most environmentally-friendly
method of lighting. Use two relighters and approx. 1.5 kg of dry
kindling sticks to quickly create a glowing layer of wood. Place
the relighters directly under the top layer of kindling sticks.
2. Open the air supply as much as possible. This is done
using the handle beneath the door. The handle is pushed
fully to the right.
3. After the paper/solid alcohol tablets have caught re,
leave the re door ajar, so that the chimney draws well.
4. When you can see that the chimney is hot enough to draw
(after 5 - 10 minutes), close the door. If all the necessary condi-
tions are met, a thick layer of embers will have been formed in
the combustion chamber after another 15 - 20 minutes, and
there will be a high temperature in the combustion chamber,
which is necessary in order to be able to continue the com-
bustion.
2.1 Lighting and fuelling intervals
A lot of air is needed when lighting the stove. If you are starting with a cold stove, the door
should be left ajar for the rst few minutes, and the combustion air supply opened to maxi-
mum. Always keep a couple of centimetres of ash in the bottom of the combustion cham-
ber. This will have an insulating eect, and ensures good combustion.
The stove’s rated heat output is 5.7 kW. Your new Morsø stove is EN-tested for ring with
wood, and is suitable for intermittent use.