Instructions

Sprog

2.3 Support arms for the Morsø S122-22

Remove the screws for the

support arms

Remove the xing screws

and rotate the support arms

so they are horizontal.

Fit the support arms with

the xing screws.

The S122-22 tted with sup-

port arms

The insert can now be mo-

ved.

Note: When removing the

support arms, the screws

must be re-tted in the in-

sert.

This is to prevent leaks in

the combustion chamber

2.4 Chimney requirements

Before setting up or installing a Morsø inset, the dimensions and quality of the chimney

must be checked against existing local/national regulations. The mathematical proof for

the correct function of the chimney is stated in accordance with DIN EN 13384. The cal-

culation takes into account that even the very large volume of air that will occur with an

open door (when adding rewood) can be removed safely.

The correct function of the inset depends on correct the chimney conditions.

It is important to ensure that all openings that lead to the same chimney, e.g. the clea-

nout door, are closed.

Several connections to the same chimney:

All Morsø’s insets in these instructions have been tested to DIN EN 13 229 with self-clo-

sing door (labelled A1) and approved. These units can be connected to a chimney with

several connections (apart from chimneys with balanced ventilation). The calculation

has been done in accordance with DIN EN 13384 part 2.