Instructions

DK ENG

Removing/installing vermiculite parts (brick panel, rear brick

and bae plates). Vermiculite should only be removed/in-

stalled when the stove is cold

1. Start by emptying the cold stove of ash. Lift the diaphragm

and stand it edgeways

2. With one hand, lift the bottom bae plate. With the other

hand, lift the brick panel up a few centimetres. This is best done

with a slotted screwdriver or similar. Once the brick has been

lifted, tip the diaphragm back into place, so the brick panel is

now released and can be lifted out.

3. Once the rst brick panel has been removed from the

stove, the diaphragm can be lifted and removed.

4. Lift the bottom bae plate again and tip the other brick

panel out.

5. Lift the bottom bae plate free of the tertiary combus-

tion air box and remove it.