Instructions

2 3
DK ENG
1.0 Installing your Morsø stove Page no.
1.1 Unpacking the stove 3
1.2 Installing the stove 3
1.3 Chimney sweep 3
1.4 Location of the stove/distance requirements 3
1.5 The chimney 4
1.6 Pipe connections 5
1.7 Connecting to a brick chimney 6
1.8 Connecting to a steel chimney 6
1.9 Draught 7
2.0 Firing/using the stove 8
2.1 Lighting instructions and fuelling intervals 9
3.0 Routine stove maintenance 12
3.1 External maintenance 12
3.2 Internal maintenance 12
3.3 Cleaning the stove 13
4.0 HETAS amendments 14
Enjoy your new Morsø stove!
Morsø, the biggest stove company in the Danish mar-
ket, has been making wood-burning stoves of the
highest quality since 1853. Just follow the instructions
below, and we are certain that you will be able to use
and enjoy your new stove for many years.
Additional accessories
Morsø also oers a comprehensive line of oor plates and accessory products that can fa-
cilitate the safe and ecient operation and maintenance of your Morsø stove.
Cast iron
Cast iron is a live material. There are no two ovens that are identical. This is partly due to the
tolerances of the casting process, partly because the ovens are a work of craftsmanship.
Minor unevennesses may also occur in the cast iron surface.
Contents
1.0 Installing your Morsø stove
1.1 Unpacking the stove
1412: After removing the outer packaging, atten
it and lay onto the oor close to the stove; this can
then act as protective work surface during the as-
sembly process.
Next, remove the legs from inside the stove. Careful-
ly lift the stove from the wooden pallet and gently lay
the stove onto its back and unscrew the heat shield
from the underside of the stove. Now screw the legs
and the Heat shield into position on the underside
of the base. Following the removal of the wooden
packaging the heat shield must be tted to the un-
derside of the stove at the same time as the legs uti-
lising the same xing bolts. Please see drawing.
The stove should now be lifted and moved into the
upright position, avoiding excess load on the back
legs.
1442: Carefully lift the stove from the wooden pallet and set it carefully in place.
1452: The assembly of the soapstone stove 1450 is described separately and instructions
are enclosed with the soapstone packaging.
We recommend that two people perform the assembly and installation procedure. The Morsø
1412 weighs 70 kg, while the Morsø 1442 weighs 80 kg and the 1452 weighs 120 kg.
1.2 Installing the stove
The stove and chimney installations MUST comply to all current National and Local Building Regu-
lations; your approved Morsø dealer or your local building control ocer can advise regarding this.
Ultimately, it is you and your installer who is responsible that the installation complies.
1.3 Chimney sweep
It may also be wise to consult your local chimney sweep before installing the stove. After your
stove has been installed, it is advisable to have the chimney checked and swept at least once a
year. In any case, if your chimney has not been used for some time, it should be inspected for
cracking, bird nests, etc. before it is put back into use.
1.4 Stove placement/clearance requirements
Minimum Clearance requirements apply if the stove is placed near to combustible materials.
Permitted clearances to combustible materials are also indicated on the data plate on the
rear of the stove.