Instructions

1110
8. Once the new fuel has taken, adjust the secondary air
amount to the desired setting; optimal combustion will
continue until glowing embers are produced.
Make sure that there is always enough air (oxygen)
to maintain clear, lasting ames when, and after, re-
ducing the amount of combustion air.
Under normal chimney draft conditions, expect to re-
fuel your stove every 60 - 70 minutes.
9. A new charge of wood can be added by repeating steps
5 & 6.
5. Refuelling of your stove should be done while there
are still glowing embers in the bed. Spread the embers
across the bottom, but concentrated mostly towards
the front of the stove.
6. Place three pieces of fuel weighing roughly 0.6 kg and
measuring about 25 cm in length across the embers in
one layer, with spacing of roughly 1 cm between the pi-
eces of wood. Recommended length and weight are
shown on the diagram on page 9..
7. When the secondary air supply is opened all the way
and the door is closed, the new fuel will ignite in a few
minutes.
Important!
It is important that the fresh quantity of wood
starts to burn quickly. To ensure the fuel lights
quickly, open the combustion air to max. or le-
ave the door ajar to allow in the amount of air
needed to light the wood.
If, however, the wood only smoulders, there will
be a strong build-up of smoke, which at worst can
cause an explosive ignition of the ue gases with
the risk of material damage and personal injury.