Operator`s manual

BARTELL MORRISON INC. BARTELL MORRISON (USA) LLC
375 ANNAGEM BLVD, MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-364-4200 FAX [phone]
200 COMMERCE DRIVE, FREEHOLD, NEW JERSEY, USA, 07728, 732-566-5400 FAX [phone]
Created: 07/04
Revised: 06/14
7. Be certain the spray wand is off before turning the bypass valve to the off position
to pressurize the system.
8. Turn the bypass valve to the off position. You are now ready to spray.
9. Adjustments to the spray pattern can be made with the nozzle at the end of the
spray wand. Turn the nozzle counterclockwise to narrow the spray pattern, and
clockwise to broaden the spray pattern.
Fig. 7
10. The sprayer has an adjustable pressure relief valve (See Fig. 8) on the block
assembly. You may need to vary the pressure according to the viscosity of the
material you are using. Thinner liquids tend to need more pressure to assure a
good coverage pattern. It is recommended to use a lower pressure setting for
certain liquids, especially with higher solids, as high pressures can be
problematic.
Fig. 8
CAUTION: NEVER EXCEED 100 PSI (S151) or 150 PSI (S201)