Petrol Blower BL260E S2 & BL 260 S2 Including Engines 1E34F-2E & 1E34FB Owner’s Manual Important Please read this Owner’s Manual and the Express Warranty before using this product. The Warranty does not cover damage due to misuse or failure to follow the operating and assembly instructions. Keep these instructions in a safe place for future use. www.morrisonoutdoor.com Part No: 548313.B.
Do not operate this machine before it has been assembled correctly and you have read and understood these instructions. 3. 4. These instructions are intended as a general guide and do not supersede national or local codes in any way. Contact local Authorities for clarity of laws relating to operation of this appliance. 5. 6. 7. Keep the instructions in a safe place for future use. 8.
Assembling the Blower Place the blower upright on the ground or on a sturdy work surface. Grasp the straight tube as shown, and push the tube over the blower discharge port and locking pins. Lock the straight tube to the blower discharge port by rotating the tube as shown. Grasp the nozzle tube with the label “TOP” positioned as shown, and then push the nozzle over the straight tube and locking pins. Lock the nozzle tube to the straight tube by rotating the nozzle tube as shown.
Self tapping screw Important! Blower tubes and the intake cover must be installed while adjusting engine idle! Engine idle speed will also be affected if either the intake cover or blower tubes are blocked, damaged or incorrectly installed! Stopping the Engine Cool the engine by allowing it to run at idle for 2 to 3 minutes. Stop the engine by pulling the ignition switch.
or of the wrong size. Low Power Output Engine does not start What to Check Possible Cause Does the engine crank? Faulty recoil starter. Fluid in the crankcase. Internal damage. Return blower to dealer Good compression? Loose spark plug. Excess wear on cylinder, piston, rings. Tighten and re-test. Return blower to dealer Does the tank contain fresh fuel of the proper grade? Fuel/mixture incorrect, stale, contaminated.
Additional Problems Symptom Possible Cause Remedy Poor acceleration. Clogged air cleaner element. Clean the element. Clogged fuel filter. Replace the fuel filter as required. Carburettor mixture too lean. Return blower to the dealer. Idle speed set too low. Adjust: 2800-3000 rpm. Fuel tank empty. Refuel. Clogged fuel filter. Clean or replace the fuel filter as Engine stops abruptly. required. Water in the fuel. Drain; replace with clean fuel. Shorted spark plug or loose terminal.
Morrison, a division of Masport Limited 1-37 Mt Wellington Highway, Panmure Auckland 1060 New Zealand P: 0800 627 767 Masport Australia Pty Limited 1/40 Abbots Road, Dandenong South Victoria 3175 Australia P: 1300 366 225 Copyright© Morrison
