40715 Rev 1 31/5/05 9:11 AM Page 1 Semi-electronic iron steam/spray/shot Please read and keep these instructions getting the best from your new iron... • Safety first Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing. • Jet cleaning Your iron will give the best ironing results and will last longer if you apply jet cleaning after each period of ironing. www.morphyrichards.co.
40715 Rev 1 31/5/05 9:11 AM Page 2 Important safety instructions around the iron before storing. Other safety considerations • Use the iron only for its intended use. • Always disconnect the iron from the electrical socket when filling with water or emptying, and when not in use. • Do not operate the iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron, but telephone Morphy Richards for advice.
40715 Rev 1 31/5/05 9:11 AM Page 3 Electrical requirements WARNING : The plug removed from the mains lead, if severed, must be destroyed as a plug with a bared flexible cord is hazardous if engaged into a live socket outlet. Should the fuse in the 13 amp plug require changing a 13 amp BS1362 fuse must be fitted. WARNING: This appliance must be earthed. Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A.C. (Alternating current).
0715 Rev 1 31/5/05 9:11 AM Page 4 Components of your iron ⁄ It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you’ll save time and electricity. Filling ¤ ‹ ‰ fi fl ⁄ ¤ ‹ › fi fl ‡ · ‚ „ ‰ 1 Make sure that the iron is not plugged in and then set the variable steam control ⁄ to the ‘0’ position before filling the iron with water.
40715 Rev 1 31/5/05 9:11 AM Page 5 Temperature control Spray Press the spray button ‹ and aim the spray of water at stubborn creases. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed. B Increase temperature Decrease temperature Variable steam Fill the iron with water as described in ‘Filling’, page 4 and insert the plug into the electrical socket.
40715 Rev 1 31/5/05 9:11 AM Page 6 Shot of steam Press the shot of steam button ¤ to obtain a burst of extra steam for ironing out creases in heavy material such as denim etc. The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set within the steam range. Do not use shot of steam at temperatures below the steam range shown on the control dial. Note: For optimum steam quality, do not operate the shot more than three times in succession.
40715 Rev 1 31/5/05 9:11 AM Page 7 Maintenance Do not store in the box, but in an upright position, so that any drops of water remaining cannot leak out and discolour the soleplate. Important: The flex can be damaged if wound too tightly around the iron after use. Make a loose loop with the flex and wrap it around the iron. The iron must be cool before winding the flex and storing on its heel.
40715 Rev 1 31/5/05 9:11 AM Page 8 Your two year guarantee It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. Model no. Serial no. All Morphy Richards products are individually tested before leaving the factory.
