40701 rev 1 3/1/06 2:50 PM Page 1 Comfigrip iron steam/spray/shot Please read and keep these instructions getting the best from your new iron... • Safety first Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing. • Jet cleaning Your iron will give the best ironing results and will last longer if you apply jet cleaning after each period of ironing.
40701 rev 1 3/1/06 2:50 PM Page 2 Important safety instructions around the iron before storing. Other safety considerations • Use the iron only for its intended use. • Always disconnect the iron from the electrical socket when filling with water or emptying, and when not in use. • Do not operate the iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron, but telephone Morphy Richards for advice.
40701 rev 1 3/1/06 2:50 PM Page 3 Electrical requirements WARNING : The plug removed from the mains lead, if severed, must be destroyed as a plug with a bared flexible cord is hazardous if engaged into a live socket outlet. Should the fuse in the 13 amp plug require changing a 13 amp BS1362 fuse must be fitted. WARNING: This appliance must be earthed. Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A.C. (Alternating current).
0701 rev 1 3/1/06 2:50 PM Page 4 Components of your iron ¤ ‹ Filling 1 Make sure that the iron is not plugged in and then set the variable steam control ⁄ to the ‘0’ position before filling the iron with water. 2 Lift up the fill cap and fill the water through the filling hole › into the water tank ·, using the beaker provided. A After filling replace the fill cap. In hard water areas the use of distilled or demineralised water is recommended.
40701 rev 1 3/1/06 2:50 PM Page 5 If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light „ which will go on and off while you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you’ll save time and electricity.
40701 rev 1 3/1/06 2:50 PM Page 6 Life long anti-scale system Vertical steam Hold the iron in a vertical position between 1cm and 2cm away from the item D. Press the shot of steam button ¤, this will create vertical steam. This feature is especially useful for removing creases from hanging clothes, curtains, wall hangings, etc. Note; For optimum steam quality, do not operate the shot more than three times in succession.
40701 rev 1 3/1/06 2:50 PM Page 7 Maintenance Helpline Jet cleaning Your iron has a built in cleaning system designed to keep the water valve, steam chamber and steam vents clear of lint and loose mineral deposits. The ‘jet clean’ should be operated after each period of ironing. To operate, ensure that there is little water in the tank, place the iron on its heel and turn the temperature control dial to the maximum setting.
40701 rev 1 3/1/06 2:50 PM Page 8 Your two year guarantee It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. Model no. Serial no. All Morphy Richards products are individually tested before leaving the factory.
