40622 Rev 1 31/5/05 9:01 AM Page 1 Profile iron steam/spray/shot Please read and keep these instructions getting the best from your new iron... • Safety first Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing. www.morphyrichards.
40622 Rev 1 31/5/05 9:01 AM Page 2 Important safety instructions Other safety considerations • Use the iron only for its intended use. • Always disconnect the iron from the electrical socket when filling with water or emptying, and when not in use. • Do not operate the iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron, but telephone Morphy Richards for advice.
40622 Rev 1 31/5/05 9:01 AM Page 3 Electrical requirements WARNING : The plug removed from the mains lead, if severed, must be destroyed as a plug with a bared flexible cord is hazardous if engaged into a live socket outlet. Should the fuse in the 13 amp plug require changing a 13 amp BS1362 fuse must be fitted. WARNING: This appliance must be earthed. Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A.C. (Alternating current).
0622 Rev 1 31/5/05 9:01 AM Page 4 Components of your iron Filling ¤ ⁄ 1 Make sure that the iron is not plugged in and then set the variable steam control ⁄ to the ‘0’ position before filling the iron with water. 2 Lift up the fill cap and fill the water through the filling hole › into the water tank ·, using the beaker provided. A After filling replace the fill cap. In hard water areas the use of distilled or demineralised water is recommended.
40622 Rev 1 31/5/05 9:01 AM Page 5 This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you’ll save time and electricity. Variable steam Fill the iron with water as described in ‘Filling’, page 4 and insert the plug into the electrical socket.
40622 Rev 1 31/5/05 9:01 AM Page 6 Vertical steam Hold the iron in a vertical position between 1cm and 2cm away from the item D. Press the shot of steam button ¤, this will create vertical steam. This feature is especially useful for removing creases from hanging clothes, curtains, wall hangings, etc. Note; For optimum steam quality, do not operate the shot more than three times in succession. Important: The flex can be damaged if wound too tightly around the iron after use.
40622 Rev 1 31/5/05 9:01 AM Page 7 Your two year guarantee To qualify for the 2 year guarantee the appliance must have been used according to the manufacturers instructions. For example appliances should have been regularly maintained. It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. Model no.
40622 Rev 1 31/5/05 9:01 AM Page 8 Morphy Richards products are intended for household use only. Morphy Richards has a policy of continuous improvement in product quality and design. The company, therefore reserves the right to change the specification of its models at any time.
