User Guide

4
Components of your iron
⁄ Shot of steam button
¤ Variable steam/boost control
‹ Spray button
› Filling hole with cap
fi Spray nozzle
fl Soleplate
‡ Water tank
· Digital LCD display
‚ Function button
„ Filling beaker
Before use
Note: The steam facility should only be
used on garments which are suitable for
ironing at the 2 and 3 dot and MAX setting.
When ironing with the steam facility at the
2 dot setting, the steam output should be set
at the lower end of the steam range (see
variable steam section).
Textiles and clothes are supposed to carry
ironing instructions. If they don’t you should
follow the fabric guide on page 3, but be sure
to test the temperature by ironing the hem of
the garment or similar area first.
If you reduce the temperature from a hot
setting to a cooler setting, wait until the iron
temperature has stabilised before you
continue ironing.
Filling
1 Make sure that the iron is not plugged in
and then set the variable steam control ¤
to the ‘0’ position before filling the iron
with water.
2 Lift up the fill cap and fill the water through
the filling hole › into the water tank ‡,
using the beaker provided. A After filling
replace the fill cap. In hard water areas the
use of distilled or demineralised water is
recommended.
Never use battery topping up fluid or
water containing any substances like
starch, or sugar, or defrosted water
from a refridgerator.
3 Always pour out the remaining water after
use. Warning: When filling your iron
with tap water always use the beaker
provided. Never fill directly under the
tap.
Temperature controls
Plug in the iron and switch on. The
temperature will default to the MAX setting B
and one beep can be heard, but don’t start
ironing immediately. If you wait a few
minutes, the iron will stabilise at the required
setting.
• To indicate that the iron is heating up
arrow above the thermometer symbol
will flash.
⁄
¤
‹
›
fi
fl
‡
·
A
B
„
‚
digital iron RN40621M Rev 1 14/3/03 5:14 AM Page 5