Comfi-grip iron steam/spray/shot Please read and keep these instructions getting the best from your new iron... • Safety first Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing. • Jet cleaning Your iron will give the best ironing results and will last longer if you apply jet cleaning after each period of ironing. www.morphyrichards.co.
Important safety instructions Other safety considerations • Use the iron only for its intended use. • To protect against the risk of electric shock do not put the appliance in water or in any other liquid. • Always disconnect the iron from the electrical socket when filling with water or emptying, and when not in use. • Do not operate the iron with a damaged cord or if the iron has been dropped or damaged.
Electrical requirements • Warning: when not in use, your iron should never be placed flat and left on an ironing board. • To prevent damage to the textile being ironed, follow the temperature guide carefully. (Test the inside of the hem of the garment). • When ironing is complete, remove the plug from the socket, empty any remaining water from the tank, and allow to cool before storage. • If you drop or severely knock your iron this could cause internal damage even if the outside appears alright.
Filling Components of your iron ¤ ⁄ 1 Make sure that the iron is not plugged in and then set the variable steam control ⁄ to the ‘0’ position before filling the iron with water. 2 Lift up the fill cap and fill the water through the filling hole › into the water tank ·, using the beaker provided. A After filling replace the fill cap. In hard water areas the use of distilled or demineralised water is recommended.
This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you’ll save time and electricity. higher steam C lower steam The steam facility should only be used on garments which are suitable for ironing at 2 and 3 dot setting. Features of your iron Temperature indicator light The indicator light shows that the iron is warming up.
No drip system Your iron is fitted with a no drip system which is designed to prevent water escaping from the soleplate when the iron is too cold. During use, the no drip system may emit a loud click, particularly during heat-up or whilst cooling down. This is perfectly normal and indicates that the system is functioning correctly. Filling / Refilling your antiscale cartridge 1 Empty any remaining water from the tank, (see emptying and storing section).
Replacement anti-scale refills To obtain replacement anti-scale refills telephone our spares number on: 0870 167 6646. Water hardness Refill interval Soft Medium 6 3 After this cleaning operation, empty out any remaining water. To clean a stainless steel or anodised soleplate (certain models only) To keep the soleplate of your iron clean and free of limescale, we recommend that you use one of the gentle chrome, silver or stainless steel cleaners that are generally available.
Your two year guarantee It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. Model no. Serial no. All Morphy Richards products are individually tested before leaving the factory.
