‘Glam It Up’ Beauty Mirror Model 25014 Instructions
Thank you for buying your new Morphy Richards, Mark Hill beauty mirror. Please read these instructions carefully before use and keep in a safe place for future reference.
Using your beauty mirror Replacing the light bulb Place the mirror on a hard, level surface. Ensure the appliance is switched off and the plug has been removed from the electrical socket. Plug in the power source. Loosen the angle locking device slightly and swivel mirror to either standard reflection or triple magnification. Use a small screwdriver to remove the two screws at the rim of the mirror. Carefully remove the rim section and replace the bulb inside with a bulb of the same specification.
Important Safeguards Cleaning When using your beauty mirror, basic safety precautions should always be followed. Ensure the unit is switched off and unplugged. Wipe the exterior of the mirror with a slightly damp cloth. 1 2 If necessary a small amount of liquid detergent could be added. Never under any circumstances use abrasive cleaners as these will cause damage to the surface of the appliance. 3 4 5 6 7 8 9 Read all instructions carefully.
Wiring Mains Lead This product is fitted with a 13A (BS1363) plug. A 3 amp fuse (BS1362) must be used. As a safety precaution and to prolong the life of your appliance, do not wrap the mains lead around the appliance as this will cause damage. Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A.C. (Alternating Current).
Two Year Guarantee It is in your interest to retain the retailers receipt as proof of purchase. Please quote the model number if the product develops a fault. This number can be found on the handle of the product. All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced.