user manual

5
Fitting the
underblanket to the
bed
• NOTE: This product can be used
with any type of bedding
including waterproof bed
protectors.
• Use only as an underblanket and
do not use above the occupant
of the bed.
• The blanket must be secured to
the mattress in the following
manner. Place the blanket
directly on the mattress and
ensure that a space of 10-15cm
(4-6 inches) is left between the
bottom edge of the blanket and
mattress A.
• Place the underblanket directly
onto the mattress. Making sure
the control switch end is at the
head of the bed, with the
connector facing upwards.
• WARNING: Ensure the blanket
is not folded, rucked or
creased. When in use do not
cover with pillows.
Fitting instructions
• Each blanket is fitted with 3 tie
cords.
• Position the blanket on the bed
ensuring the pillow area is clear.
• Do not stretch the cord too
tightly. Allow some ‘give’ to
avoid edge distortion. Ensure
knots are not tied too tightly so
that they can be undone easily.
• Pass the first tape ⁄ under the
corner of the mattress.
• Thread up through the centre
eyelet.
• Pass under the adjacent corner
and tie off to opposite loop.
• Repeat for second tape ¤ at
opposite end of the blanket.
• Pass the centre tape ‹
underneath the mattress and tie
to opposite loop.
• If the tape is too long you can
cut off the ends.
A
⁄
‹
¤
For details of other Morphy Richards products, please see our website:
EB75179 MUK Rev 1_Instruction Booklet 17/12/2010 09:31 Page 5