Carpet Cleaner User Manual

Features
⁄ Waste tank
¤ Motor housing
‹ Power switch
› Tank latches
fi Castors
fl Inlet
‡ Hose end
· Carrying handle
‚ Hose
„ Curved handle
‰ Extension tubes
 Floor nozzle
Ê Bolt
Á Screw
Ë Wheel
È Hub cap
Í Exhaust filter flap
Î Cable storage hook
Ï Cardboard collar (on paper bag)
Ì Tool storage cart
Ó Cartridge filter
Ô Bucket
 Foam filter
Ò Foam filter locking plate
Ú Crevice tool
Û Upholstery tool
Assembly
1 Release the tank latches and lift off the
motor housing as shown D.
2 Remove any parts stored for transit inside
the tank.
3 Turn the tank upside down. To fit the
wheels, slot a bolt through the centre of a
wheel, push the bolt into the hole on the
side of the cart and secure by inserting a
screw B1 .
4 Now fit a hub cap B1 . Do the same for
the other wheel.
5 Push the 2 castors into the holes and
press firmly B2 .
6 Refit the motor housing ensuring that the
switch is positioned above the inlet as
illustration A. If the motor housing is
fitted in any other position the latches will
not lock.
•Press the middle and not the bottom of
the latch to lock.
7 Assemble hose, extension tubes and
nozzles as required, see A. Insert the
hose end into the tank inlet and twist to
secure.
Wet & dry vacuuming usage
4
70223 Rev 2 9/8/04 4:00 PM Page 4