TS-MPPT-600V-48 Manual
21TriStar MPPT 600V Operator’s Manual
20
Installation
High Voltage Wiring
Below the Removable
Wiring Divider
Figure 3-1. Low voltage and high voltage wirin
Low Voltage Wiring
Above the Removable
Wiring Divider
g zones (shaded areas)
3.3 Conduit Knock-Outs and Wire Routing
Knock-outs are provided for routing cables through conduit or wire glands. Table 3-1 details the
knock-out sizes and quantity provided on the TriStar MPPT 600V wiring box. Knockout place-
ment dimensions are on the inside front cover. Figures 3-2 to 3-5 show knock-out types.
The TriStar MPPT 600V wiring box provides continuous and separate paths for high voltage
(solar) and low voltage (battery & COM) wiring routing. These allow wiring to pass between
TriStar MPPT 600V controllers that are mounted side-by-side without the need for external con-
duit tubing. Table 3-1 identies the pass-through knock-outs which may be used for this purpose.
Figure 3-6 shows the routing of the high voltage and low voltage wiring paths.
2
3
4
1
5
6
Figure 3-2. Knock-outs, left view
2
1
4
5
6
Figure 3-3. Knock-outs, right view