TriStar MPPT 600V Installation & Operation Manual

9TriStar MPPT 600V Operator’s Manual

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a resi-

dential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and

usedinaccordancewiththeinstructionmanual,maycauseharmfulinterferencetoradiocommunication.However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment on and off, the user

is encouraged to try to correct the interference by one or more of the following measures:

• Re-orient or re-locate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada.

2.3 Versions and Ratings

There are two versions of TriStar MPPT 600V controller:

TS-MPPT-60-600V-48

• Maximum 60 amps continuous battery current

• 48 volt DC systems

• Maximum 600 volt DC solar input voltage

• RS-232, EIA-485, MeterBus

, and Ethernet communication ports

TS-MPPT-60-600V-48-DB

• Maximum 60 amps continuous battery current

• 48 volt DC systems

• Maximum 600 volt DC solar input voltage

• RS-232, EIA-485, MeterBus

, and Ethernet communication ports

• Includes enhanced wiring Disconnect Box (DB) with PV and battery disconnect switches