TriStar MPPT 600V Installation & Operation Manual

21TriStar MPPT 600V Operator’s Manual
Figure 3-7. Remove the wiring box cover.
Step 2 - Remove the Wiring Divider (TS-MPPT-60-600-V48 and TS-MPPT-60-
600V-48-DB) and Solar Terminal Bridge (TS-MPPT-60-600V-48 ONLY)
The wiring divider separates the solar high voltage wiring from the low voltage battery and com-
munication circuits. See Figure 3-8 . The divider is secured with only one screw.
1. Use a #2 Philips screw driver to remove the screw.
2. Lift and tilt the divider towards the bottom of the unit as shown in Figure 3-8.
3. Lift the divider out of the wiring box and set the divider and screw aside. The divider
must be replaced in a later step.