TriStar MPPT 600V Installation & Operation Manual

13TriStar MPPT 600V Operator’s Manual
1 - Heatsink
Aluminum heatsink to dissipate controller heat (the TriStar MPPT 600V is 100% passively cooled for reliability)
2 - Battery Negative Power Terminal
Power connection for (-) battery cable termination
3 - Battery Positive Power Terminal (red)
Power connection for (+) battery cable termination
4 - Settings Switches
Eight(8)settingsswitchestocongureoperationoftheTriStarMPPT600V-DB
5 - MeterBus
TM
Port
RJ-11 socket for Morningstar MeterBus
TM
network connections
6 - Ethernet Port
RJ-45 socket for LAN/internet connections
7 - Serial RS-232 Port
9-pin serial connector (female)
8 - EIA-485 Port
Four (4) position screw terminal for EIA-485 bus connections
9 - Battery Terminal Blocks
Power connection points for Battery (+) and (-)
10 - Grounding Terminals
Chassis terminals for system grounding
11 - Solar Terminal Blocks (one shown)
Power connection points for solar (+) and (-)
12 - Auxilliary DIN Rail Mounts
13 - Battery Breaker
Battery (+) disconnect point
14 - Grounding Terminal
A chassis terminal for system grounding
15 - Solar Disconnect Switch
Solar (+) disconnect switch
16 - Solar Terminal Bridge (yellow)
Isolates high voltage PV wiring from low voltage wiring area
17 - Solar Negative Power Terminal
Pre-wired connection point for (-) solar cable termination
18 - Solar Positve Power Terminal
Pre-wired connection point for (+) solar cable termination
19 - Battery Voltage Sense Terminals
Terminals for battery voltage input provide accurate battery voltage measurement
20 - Push-button Switch
Manually reset from an error or fault, also used to start/stop a manual equalization.
21 - Remote Temperature Sensor Terminals
Connection point for a Morningstar RTS to remotely monitor battery temperature
22 - LED Indicators
Three state of charge (SOC) LED indicators show charging status and controller faults