TriStar Manual

41TriStar MPPT Operator’s Manual
Faults & Alarms
• Over-temperature Y / R sequencing
• High voltage disconnect G / R sequencing
• DIP switch fault R / Y / G sequencing
• Self-test faults R / Y / G sequencing
• Remote Temperature Sensor (RTS) G+Y / Y+R sequencing
• Battery voltage sense G+Y / Y+R sequencing
• Battery over-current R+Y / G sequencing
Battery State-of-Charge LED Indications
G 80% to 95% SOC
G+Y 60% to 80% SOC
Y 35% to 60% SOC
Y+R 0% to 35% SOC
R battery is discharging
RefertotheSpecications(Section8.0)fortheState-of-Chargevoltages.
Note that because these State-of-Charge LED displays are for all battery types and system de-
signs, they are only approximate indications of the battery charge state.
Ethernet Jack Indications
In addition to the SOC LEDs, two (2) small LEDs can be found on the Ethernet RJ-45 jack inside
the wiring box. These LEDs indicate the LAN/WAN network link and activity status as follows:
Condition Green LED Yellow LED
Network Connection OK ON OFF
Network Activity ON Blinking
Error OFF ON