SunSaver MPPT Installation and Operation Manual

MORNINGSTAR CORPORATION

2.0

2.3 Regulatory Information

NOTE:

This section contains important information for safety

and regulatory requirements.

The SunSaver-MPPT controller should be installed by a

qualied technician according to the electrical rules of the

country in which the product will be installed.

SunSaver-MPPT controllers comply with the following

EMC standards:

• Immunity: EN61000-6-2:1999

• Emissions: EN55022:1994 with A1 and A3 Class B1

• Safety: EN60335-1 and EN60335-2-29 (battery chargers)

A means shall be provided to ensure all pole

disconnection from the power supply. This disconnection

shall be incorporated in the xed wiring.

Using the SunSaver-MPPT grounding terminal (in the

wiring compartment), a permanent and reliable means for

grounding shall be provided. The clamping of the earthing

shall be secured against accidental loosening.

The entry openings to the SunSaver-MPPT wiring

compartment shall be protected with conduit or with a

bushing.

FCC requirements:

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2)