User manual
C) The MODBUS Address for this controller is programmed as ‘1’ from the factory. Un-
less you have programmed a different address during a previous MSView session, the
SSMPPT default address will still be ‘1’. Click Next>.
D) MSView will now write the new settings to the controller. A blue bar at the top of the
window will indicate progress. When programming is complete, click Finish.
IMPORTANT: Before closing the SSMPPT Custom Settings Summary window, you may want to save your lighting/
load conguration to the PC. Click Write to File to save this conguration for later use.
IMPORTANT: To use these newly programmed settings, DIP Switch #2 MUST BE IN THE UP (ON) POSITION.
E) The SSMPPT LEDs will now be sequencing. This is to indicate that there has been a
programming change and a restart of the controller is required. Remove one of the bat-
tery/supply connections so that the LEDs turn off, wait 10 seconds, and re-apply the con-
nection. The controller will boot through its normal LED sequence.
THE LIGHTING CONTROL PROGRAMMING IS NOW COMPLETE.
page 12 of 18