Installation Guide

10 Morningstar Corporation
need for tools. On the bottom of the Meter Hub, there are three hooks
that catch the upper lip of the DIN rail and one wide tab that snaps over
the bottom lip of the DIN rail. Hold the Meter Hub at an angle and gently
slide the three upper hooks on the back of the Meter Hub over the upper
lip of the DIN rail as shown in fi gure 2 (action #1).
Step 4
Once the hooks have engaged the upper lip of the DIN rail, rotate the
Meter Hub so that it is fl ush and parallel to the DIN rail as shown in fi gure
2 (action #2).
Step 5
Hold the Meter Hub fi rmly in position while pushing the DIN rail tab
upwards as shown in fi gure 2 (action #3). The tab will fi rmly snap when
properly engaged with the DIN rail.
!
CAUTION: Equipment Damage
Never attempt to remove the Meter Hub from the DIN-rail without fi rst releasing the DIN
rail tab. Damage to the Meter Hub will result!