Installation manual

Pelton Runner Alignment

You can view the Pelton runner by looking through

the jet as shown. The water jet needs to hit the

middle of the Pelton spoon splitter. If the jet is

misaligned then pack the runner across using the

washers supplied. You can see in the picture that the

Pelton runner needs packing to move the rotor to the

left.

8.3.4. Turgo (TRG) turbine assembly

Turgo turbines are fully assembled apart from the 4

jets.

These are assembled as shown. Grease all the

threads and tighten until snug. This is best done with

the turbine upside-down.

There is a TRG case study that will further assist you

with the installation of this product.