Installation manual

Pelton fixing washers front and rear views

 Insert M12 bolt, spring washer and washers as shown.

 Install alignment washers as shown. Note you may need to alter the position of the

washers until the centre of the jet aligns with the splitter of the Pelton spoons.

 Attach the Pelton runner to the shaft as shown below.

Attach Pelton runner to the shaft and tighten to 50 Nm (35 lb/ft).

Ensure that the drain holes in both the slinger housing top-hat and the bearing block are

pointing downwards.

Quick release glazing tabs

These tabs are provided with the PLT turbine to secure the glazing during commissioning.

Use them during set up, as they make it easy to remove the glazing. The other fixings

should be used later, for safety, if children have access.

Top hat

drain hole

points down