Installation manual

illustrated in the plan view below. Fixings are provided with the PowerSpout for connection to

a timber framed base. These dimensions are sufficient to plan for the mounting of the turbine

prior to its arrival on site. A PowerSpout PLT unit is 400 mm high.

Plan view of a PowerSpout turbine

A TYPICAL PLT TURBINE BASE:

A framed timber base made from 100x50 timbers and covered in 12-

17mm thick plywood sheet on top with a hole 160 x 390 mm cut for

the exhaust water. Remember to drill a hole so that condensation

can drain from the turbines dry side.