Installation manual

IP24 ingress IK10 impact

Model type: PLT, TRG, LH, LH Pro Rated Power: Watts

Serial number: Rated Amps Short circuit Amps

Rated speed: rpm Maximum rpm 3000 Head: m (x10 kPA) Flow: l/s

Rated volts loaded: DC New Zealand – country of origin Mass: < 25 kg

Rated volts unloaded: DC Date manufactured:

Protective class I - earth connection required Possible residual voltages - always check first

Klampit 75 120 240 not fitted Capacitor discharge time mins (if fitted)

Annual inspection needed refer to manual Guarantee 2 3 5 10 years

1. Scope of Application, and Safety

This document is part of the product.

This section addresses safety concerns as required by international standards.

If you are not technically competent, experienced and qualified you should not install this

equipment alone and should engage the services of a suitably trained professional.

Electrical equipment can be installed or operated in such a manner that hazardous

conditions can occur; compliance with this manual does not by itself assure a 100% safe

installation. If the equipment is properly selected and correctly installed and operated

according to this manual, then any such hazards will be minimized.

1.1. Turbine serial numbers

As of September 2013 all turbines have identification plates and serial numbers.

For example:

You might see 100-7S-2P-S HP F 3061 A as the serial number.

This means you have a 100 series stator, connected 7 Series and 2 Parallel fingers per

phase, High Power rotor upgrade, Filter installed for conducted emission compliance, invoice

number 3061 and other identical units were supplied at the same time labelled A, B, C, D

etc.

If you ever need to query an installation or order spares for a product take a picture of the

identification plate and forward it with your query. The generator code is also engraved on

the back of the PMA stator.