Installation manual

1.8. Connecting to the Grid (power network)

PowerSpout PLT/TRG/LH grid-tied options (no batteries required) are available for clients

that are already connected to the grid and have a good water resource close by.

In NZ, Australia and the UK the EnaSolar inverter can be used if the MPP tracking rate is

slowed.www.enasolar.net

Also Aurora wind turbine inverters from Power-One can be used in most global markets

www.power-one.com/

Also Ginlong wind turbine inverters can be used in most global markets

http://ginlong.com/Products/wind_GCI_2G.htm

Please note that SMA have recently withdrawn the Windy Boy range from the market.

WARNING

Operating voltage within a PowerSpout PLT200 disconnected from the grid and

free spinning is normally > 500 V DC. At this voltage contact means

electrocution is likely. DC is much more dangerous than the 230 VAC found in

many European countries and must only be installed or serviced by persons

trained in electrical work.

Please ensure you use a registered electrical worker who is familiar with this type of

equipment and voltages.

You should also seek guidance from your grid operator before attempting to connect.