Instruction manual

3-18
Chapter3 Advanced Operation
3
Press along the folded line of the single-
folded paper rmly with your ngers
to prevent the paper from slipping and
buckling in the horizontal direction
when folded.
Paper
Side guide
Paper set lever
36 mm/1-1/2 inches
4
Raise the paper set lever and stack the
single-folded paper on the paper feed
tray with the folded line facing the non-
operator's side.
The amount of paper stacked on the
paper feed tray should be approximately
2/3 (36 mm/1-1/2 inches) of the height of
the side guide.
5
Loosen the xing screws of the side
guides.
Side guide
Side guide
Fixing screw
Fixing screw
6
After pressing the side guide to each
side of the paper lightly, tighten the
screws to secure the side guides.
Paper set lever
7
Lower the paper set lever.
The paper feed tray will be raised.
Make sure that you lower the paper set
lever. If you start operations without the
paper set lever lowered, the paper feed
rings will run idle, causing the machine
to stop.
LP
Single fold
Count:0
8
Check if [LP] is displayed on the LCD
display. If not, press the key to
select [LP].