Instruction manual

3-13
Chapter3 Advanced Operation
Folded sample
11
Check the nish of test folding.
Check for folding misalignment using the
second test folded sample.
If folding misalignments occur, refer to
Chapter 3 "ADVANCED OPERATION"“5.
Correcting Folding Misalignment”
( p.3-20).
12
After completing adjustments, set the
count mode either to the add count or
to the subtract count, then press the
key to start folding operations.
•
Refer to Chapter2 "Basic Operation"
“1.Standard Folding of Standard Paper”
"1-3. Operation Procedures ( p.2-2).
•
For custom folding of non-standard
size paper, refer to "2.Custom Folding of
Standard Paper" ( p.3-7).
4. Cross Folding
Do not put neither hands nor ngers inside the machine during operation. You also need to be
careful not to get your hair, accessories and wear caught in the machine.
Cross fold
Cross single fold
Cross letter fold
Cross folding is to fold single-folded paper another
time into two or three.
• The maximum paper thickness is
104.7 g/m
2
(EU)/28 lb (North America).
However, this thickness may dier
slightly according to various conditions
such as environmental conditions
(temperature, humidity), paper size, and
paper ber direction.
folding
• When the paper is cross folded, Σ folding
(folding slippage in the horizontal)
and folding misalignment along sides
of paper may occur due to conditions
such as environmental conditions
(temperature, humidity), paper size
and paper ber direction. This is not a
malfunction of the machine.