Instruction manual

3-12
Chapter3 Advanced Operation
Side guide
Side guide
Fixing screw
Fixing screw
4
After pressing the side guide to each
side of the paper lightly, tighten the
screws to secure the side guides.
Paper set lever
5
Lower the paper set lever.
The paper feed tray will be raised.
Make sure that you lower the paper set
lever. If you start operations without the
paper set lever lowered, the paper feed
rings will run idle, causing the machine
to stop.
LP
Single fold
Count:0
6
Press the key to set the paper size
to [LP].
A3
Single fold
Count:0
7
Press the key to set the folding mode.
Paper length
297.0mm
8
While pressing the key, press the
or key to change [paper length] from
[297.0mm](EU)/[11.00inch] (North
America) to the length measured in step
1.
9
Press the key for test folding and
check if the paper is ejected smoothly.
If mis-feed or double-feed occurs, refer to
Chapter2 "Basic Operation" “1.Standard
Folding of Standard Paper” "1-3. Operation
Procedures ( p.2-2).
10
If the paper is not ejected smoothly,
change the position of the stacker
rollers again.