Instruction manual

3-2
Chapter3 Advanced Operation
Operation Procedures ( p2-2).
After completing single folding of thick
paper, turn o and on the power to
return the folding stopper to its original
position. If thin paper is single-folded
before doing this procedure, the thin
paper will not be folded neatly.
1-2. Double Folding Thick Paper
When folding ne quality thick paper 104.7 g/m
2
/28 lb into four, its folding section may open when ejected
to the stacker because of the paper thickness and consequently the folded paper may not be able to pass
through the stacker rollers, resulting in paper jam. To prevent this, follow the procedures below.
Do not fold ne quality thick paper 127.9 g/m
2
/34 lb into four because paper jam inside the
machine or paper ejection problem may occur.
Side guide
Fixing screw
Side guide
Fixing screw
1
Loosen the xing screws of the side
guides, and move the side guides to t
the paper width.
Paper
Paper set lever
Guide plate
2
Raise the paper set lever and place
some paper on the paper feed tray.
Push in the paper until its lead edge touches
the guide plate.
Side guide
Side guide
Fixing screw
Fixing screw
3
After pressing the side guide to each
side of the paper lightly, tighten the
screws to secure the side guides.