Instruction manual

1-6
Chapter1 Before Operation
First folding plate
UNLOCK
LOCK
Lock lever
2
Attach the rst folding plate.
1) Move the lock lever of the rst folding plate
to the position of “UNLOCK.”
2) Slide the rst folding plate to the machine
along the shaft on each side of the frame,
then insert the U-shaped gutter on the
edge of each side into the shaft located on
the back of the frame.
3) Move the lock lever to the position of
“LOCK.”
Connector 1
Control cable 1
Control cable 2
1
2
2
1
Connector 2
3
After attaching the folding plates,
connect the control cable of the rst
folding plate to the connector "1" and
that of the second folding plate to the
connector "2."
• Be careful not to connect the control
cable to a wrong connector.
• Be sure to turn o the power before
connecting or disconnecting the
control cable. Otherwise the unit will
malfunction.
Guide plate unit
4
Place the guide plate unit on the
magnet under the top cover.
Cross folding lever
5
Insert the cross folding lever to the
shaft located on the operator's side
under the top cover.