Specifications

Page 25
SYSTEM
SET BY POSITION
IMPORTANT NOTES.
1. If the fold is too near, or on the center line of the crease; the fold will try to fold
diagonally across the crease profile and pull the fold out of square to the paper.
The best fold squareness is achieved when the fold is on the center line of the
crease, it should be to one side of the crease center line as shown below.
Thus for a crease setting of 100 for example, the fold should be set to a figure
slightly smaller or greater than 100.
2. When using all dimensions are from the leading edge of the paper
as shown in the example on page 26.
not
Set By Position,
center line of crease
ideal fold line
ideal fold line
DigiFold Pro
Operating the DigiFold Pro