Specifications

Page 23
SYSTEM
Fold Settings Pages.
To get to the Fold setting page click the lower tab or from the
status area.
If you have selected a predefined standard Fold Type from the paper settings page
the crease positions will be set for you. These positions can be fine tuned by
Folds in ‘Set By Fold’ mode.
± 0.1mm
increments by pressing the arrow buttons for each crease.
K1 Fold trim - On selection
the status area is replaced
with a calculator for
inputting new values.
Trim range is -5.0 to +5.0
with increments of 0.1mm
Folding can be trimmed
for fine adjustments.
Trim range is -5.0 to +5.0
with increments of
0.1mm
With Folding turned off the
deflect positioned can be
trimmed.
Trim range is -5.0 to +5.0
with increments of 0.1mm
Folding on/off selector
green is on & red is off.
This is also indicated in
the status area.
DigiFold Pro
Operating the DigiFold Pro