User's Instructions

The device under test is manufactured by the grantee (Morgan Olson, LLC), and sold as an OEM
product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, etc…, the grantee must ensure the end-user has all
applicable / appropriate operating instructions. When end user instructions are required, as in the
case of this product, the grantee must notify the OEM to notify the end-user.
Morgan Olson, LLC will supply this document to the reseller/distributor dictating what must be
included in the end user’s manual for the commercial product.
INFORMATION TO BE INCLUDED IN THE END USER’S MANUAL
The following information (in blue) must be included in the end-product user’s manual
to ensure continued FCC and Industry Canada regulatory compliance. The ID numbers
must be included in the manual if the device label is not readily accessible to the end
user. The compliance paragraphs below must be included in the user's manual.
******************************************************************************
FCC ID: 2A7IH-13001MCM20 IC: 28701-23001MCM20
This device complies with Part 15 of the FCC Rules and with ISED Canada license-exempt RSSs.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'ISDE Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Note: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.