Operating Instructions and Installation Instructions

18
section 5 - installation instructions
5.10 INSTALLING THE FLUE
FITTING FLUE THROUGH THE WALL
1. Ensure the seam and the outlet terminal are
atthetopandttedasshown.
2. OncetheueisinstalleditisIMPORTANT
that the white air duct protrudes from the
aluminiumuecollar(RSF060)atleast
17mm.
Note. If less than 50% of the length of the ue is
internal the ue should be tted from outside.
3. Fittheinternalsealingubbertotheue
(leave loose) and check protrusion externally
of the white air duct is 17mm.
4. Fit the turret as below
FITTING THE TURRET -
1. Ensuretherubbersealisttedcorrectlyontheappliancemanifoldandthatalluesealsareundamaged.
2. Holdtheuermlyandpushtheturretonuntilithastravelled30mmontotheuepipeandisfullyengaged.Makesurethe
uehasnotrotatedormovedforwardduringttingandtheueseamisuppermost.
3. Pushtheturretintothemanifoldensuringtheupperplasticlipisushwiththetopofthemanifold.
4. Fullyengagetheclamplocationsectionintothemanifoldlocationholes.Rotatedownontoturretange.
5. Secure clamp to appliance using securing screw.
6. Ensureallsamplepointsareaccessibleandallsampleplugsandcapsaretted.
7. Fullyengagetheueintotheturretandslideinternalubbertowall.
8. Thegapbetweenthealuminiumuecollar(RSF060)andthewhiteairductMUSTbesealedwithsealanttocreateaseal.
Flue Outlet
C
A
A - Duct Assembly
B - Flue Turret
C - Turret Clamp
D - Seal
Flue Outlet
D
B
Retaining
screw
Clamp Lugs
Sample points
WALL
Aluminium Flue
Collar (RSF 060)
Fill with
sealant
17mm min
Internal Sealing
Flubber
Fill with
sealant
5” hole