Operation Manual

--- Boiler Load
{Fan Speed)
a) Flow Adjustment
SEALING LABEL\--
_/
,' :
- l
OFFSET - - ,
ADJUSTMENT
7.4 Service Mode
1
--- Boller Load
{Fan Speed)
b) Offset Adjustment
FEEDBACK CONNECTION
FlOW(CO)
ADJUSTM E NT
SEA LI NG lAB EL
• Turn the CH knob fully clockwise. Status LED Service will be ON
• After the soft start time ends, the boiler will run at the minimum load.
• To operate the boiler
at the maxmum load, turn the CH knob to the off position
and back again to the service mode position within 3 seconds. (If the
CH knob
stays
in off position, the main board will cancel the service mode). The
status LED Service will blink to indicate the maximum load.
• Service mode will be inactive after 10 minutes.
• It is possible cancel the soft start function by turning the
CH knob to the
off position and back again to the service mode position within 3 seconds.
33