Operation Manual

5.2 GAS AND WATER CONNECTIONS
Connect the boiler up in such a way as to leave the connecting pipes self supporting
and free from any stress. The Gas pipe must
be supported by a clip to the bulkhead.
Check the gas pipe complies with the requirements in section 4.5.
Gas and water connections are made to the boiler as
in the diagram below:
I
®
'
CD
'
®
0 171
2 ~
3
0
4
1. CH Flow-%" BSP
2. DHW Outlet- %" BSP
3. Gas Inlet-%" BSP
4. DHW Inlet (mains)-%" BSP
5. CH Return - %" BSP
6. Condensate Drain
7. Pressure Relief- 15mm copper stub pipe
0 7
0
5
21