Specifications

consumption 52 W maximum cooling

Adapter input voltage 100-240 V AC/50-60 Hz

Adapter output voltage 12 V DC/5 A

Adapter maximum power 60 W

Power supply connector 5.5 / 2.5 mm

1. Power consumption is measured on the AC side of the supplied

12 V AC/DC power supply. Camera consumes less energy from

12 V power supply than state here.

2. The camera contains its own power supplies inside, so it can be

can be anywhere between 10 and 14 V. However, some parameters

(like cooling efficiency) can degrade if the supply drops below

12 V.

3. G3 and G4 camera measures its input voltage and provides it to the

control software. Input voltage is displayed in the Cooling tab of

the CCD Camera control tool in the SIPS. This feature is important

especially if you power the camera from batteries.

Warning:

The power connector on the camera head uses center-plus pin. Although all

modern power supplies use this configuration, always make sure the

polarity is correct if you use own power source.

Mechanical Specifications

Compact and robust camera head measures only 154×154×74 mm (approx.

6×6×3 inches). The head is CNC-machined from high-quality aluminum and

black anodized. The head itself contains USB-B (device) connector and

12 V DC power plug, no other parts (CPU box, USB interface, etc.), except

a “brick” power supply, are necessary. Integrated mechanical shutter allows

streak-free image readout, as well as automatic dark frame exposures, which

are necessary for unattended, robotic setups. Integrated filter wheel contains

5 positions for standard 2-inch filter cells with M48×0.75 thread. There are

three M3 threaded holes around each filter position, which allow fixing of

filters without cells (only a glass) up to 51 mm diameter.