User Guide
14
MAINTENANCE GUIDE
● Error code
● Troubleshooting
E01
E02
E03
E04
E05
E06
E07
Error code will be displayed in the screen when the dishwasher malfunctions.
Error code Possible cause Potential solutions
Problem Possible cause Potential solutions
Thermistor short circuit Contact customer service for help
Contact customer service for helpThermistor short circuit
Water suction malfunctions Contact customer service for help
Contact customer service for help
Overflow
Abnormal heating
Abnormal suction
The appliance can't
heat the water
Do not place the tableware leveled in case they may collect water
resulting in the lack of water which fail heating in the dishwasher.
1. Lean the appliance for 30°~45° to empty water in its bottom and restart.
2. Check if the drain hose is hung too high.
3. Check if the drain pipe is blocked, twisted or placed under heavy objects.
4. Check if the drain pipe malfunctions.
5. Contact customer service for help.
1. The tap is not open completely.
2. The water flow is slow/ water pressure is low.
3. Being started multiple times under circumstance of lacking water.
4. Contact customer service for help.
Washing powder/ pods
remain in the dishwasher
Some water and
condensation remains in the
inside of the dishwasher
Foam remains in the
dishwasher
1. The water outlet of spray arm is
blocked so that detergent powder can
not get rinsed thoroughly.
3. Bad detergent powder/ pod was used.
4. Washing powder/ pod was not put into
correct position.
2. Too much detergent powder was put
or the size of washing pod is not
small enough.
Unblock outlet on spray arm and run the
dishwasher on Rapid program to rinse foam
on tableware.
Run the Rapid program to rinse tableware with
water. Put recommended quantity of detergent into
dishwasher according to the manual at next time.
Run the Rapid program to rinse tableware with
water. Please check if detergent expires. Or try with
other brands of detergent.
When there is little foam left in the dishwasher, open
the door to make it disappear naturally. When the
there is too much foam in the dishwasher, please
clean it with tools manually.
Run any programs after removing foam manually for 3
minutes, repeat this process until all foam disappears.
Too much detergent powder was put or the
size of washing pod is not small enough.
Refer to the "Detergent adding method".
This is normal which won't affect the result.










