Contents Product dimensions 01 Connection diagram 02 ATS Technical specifications ooo 03 Application 03 Product introduction 04 Installation 04 Auto-select voltage range 05 Display interface 05 User input key functions 08 Display function selection 06 Display back light timeout 06 12v operating specifications 07 24v operating specifications 07 48v operating specifications 07 Safety instructions 08 Environmental protection notes 08 Warranty 08 Thank you very much for selecting our products.
Len ET Wind generator Ri Solar&Wind Controller 1 [=BA8%E Edam Utility Power No Wind generator ce v0] Solar&Wind Controller Utility Power N Lz 1 Load Inverter 02
fT ere, Specifications Model ATS-11KW Rated Power Power 100-120V) futility Power 220-240V) Input Voltage Auto Selection:AC 100-12V or AC 220-240V Output Voltage Auto Selection:AC 100-12V or AC 220-240V Transfer time Inverter transfer time to utility power =10ms Utility power transfer time to inverter =16ms LCD Display Battery voltage; Power source: Utility power or battery-inverter.
Product introduction The Dual Power Transfer Controller is used between an Off-Grid Power System and the Public Utility Power Supply. The ATS Controller connects separately to 1) Utility Power 2) Inverter 3) Battery 4) Load. The User Interface allows for both Monitoring of the ATS Operating State and Adjusting Voltage Set points. The Master ON / Off Switch is located at the Top of the Controller for easy access. 1.
12V system detection voltage range SV-17V 24V system detection voltage range 18V-30V 48V system detection voltage range 30V-60V Del pT Lt-aw + @ BAT ied i @ LV-SW interface--setting the switching voltage function @ BAT-V interface--normal displaying battery voltage ® HV-SW interface--setting the recovery voltage @ 12V, 24V, 48V Interface Displayed after ATS Identifies Voltage Supplied ( LCD digital: a. battery voltage b. low voltage setting switching voltage c.
LT ST a Front Panel Key Buttons: a. Add button b. Function button Minus button a.The add button is only valid in function setting voltage (0.1V per trigger). b.The function button have respectively 3 kinds of independent display interface state HV-SW, pressing the button to display circularly in order, the power-on system default display BAT-V. When the other function interface do not display trigger signal, 10 seconds to restore the system default display BAT-V interface. c.
12V System Working Specification a. Battery level-LCD display b.Detection cut off and recovery point voltage When it is detected that the battery voltage is lower than 11V for 2 seconds (system default 11V), it is the low-voltage switching voltage, and the switching action is: LCD Right arrow flashes, LCD&m Left arrow display tuned off, battery icon flashes. When detecting the battery voltage rise 13.5V for 2 seconds(system default 13.
| SAFETY RECOMMENDATIONS RECOMMENDATIONS THE FOLLOWING SAFETY RECOMMENDATIONS AND HAZARD WARNINGS PROVIDE FOR THE PROTECTION OF THE ATS CONTROLLER AND THE SAFETY OF THE USER 1. Failure to install and use this ATS Controller in a safe and proper manner, and failing to adhere to all required Electrical Standards may result in Electrocution and / or Death. Consult a Licensed /Experienced Electrician for any Questions regarding the Safe and Correct Installation and continued use of this product. 2.
The Manufacturer Warranties the ATS Controller for a period of One (1) Year against Defects in Workmanship and Materials. Service and repairs to this ATS controller may only be carried out by Factory Authorized agents and personnel. Use only original spare parts for repair work. The use of any other spare parts not authorized by the manufacturer may lead to serious damage to the controller and or adjacent property and can result in personal injury.
