Owner`s manual
Manual Part No: 930093-01 MD Electric Convection Range - 21 –
Manual Rev No: 1
User Instructions (cont.)
Cleaning the Equipment:
It will be found that it takes less time and effort if appliances are cleaned every day, particularly while
they are still warm and before grease or spillage’s are burnt on.
PROPRIETARY OVEN CLEANER MUST BE USED WITH CARE. THEY ARE HIGHLY CORROSIVE AND MAY
CAUSE DAMAGE TO SURFACES AND COMPONENTS.
Hotplates
Wipe the solid top hotplate sections clean while they are still warm - use a grease absorbing material.
DO REMOVE GREASE AND SPILLOVERS BEFORE THEY BURN ON.
If the equipment is to be out of service for any length of time apply a thin coating of cooking oil to each
section in order to prevent rust forming. Clean off before using the appliance again.
Once a week lift up the solid top plates and clean out all the accumulated debris.
Open Top Hotplates (Gas Top)
Wipe the open top pan support grids clean of grease and spillage’s regularly - even during cooking
sessions - a crust of burned on carbon, coating the pan supports is unsightly, is a health hazard and will
impair cooking efficiency.
Daily: Soak the pan support grids in a mild solution of a grease dissolving agent or detergent - DO NOT
USE A CAUSTIC CLEANING AGENT - and wash. Accumulated deposits may be removed by soaking and
then carefully scraping or a fine cleaning paste could be tried.
SOME PAN SUPPORT GRIDS ARE VITREOUS ENAMELLED - DO NOT USE CAUSTIC CLEANERS AT ALL.
WIPE OVER WITH A LIGHT COATING OF COOKING OIL AFTER CLEANING AND DRYING.
The burner caps and burner rings may be removed from the open hotplate burners for cleaning. Soak
and wash in a mild detergent solution, rinse and dry thoroughly before replacing.
DO NOT allow water
or cleaning agents to enter the burner venturi.
DO NOT use caustic cleaners on burner parts.
DO NOT scrape or poke the burner port ring, soak and then carefully BRUSH clean any stubborn
accumulations of dirt.
REPLACE THE BURNER COMPONENTS CAREFULLY IN THEIR CORRECT POSITIONS.
Brush or scrape all accumulated rubbish from the burner tube covers into the hotplate drip tray. Wipe
down with a grease absorbing material.