Owner`s manual

Manual Part No: 930093-01 MD Electric Convection Range - 16 –
Manual Rev No: 1
Installation (cont.)
Electric Connection
The connection should be made in electrical conduit, via a fused isolator on the wall adjacent to the
appliance. The final connection MUST be in flexible conduit so that the connections can be made at the
rear of the appliance before it is moved into position.
ENSURE THAT THE CONDUIT IS CLEAR OF THE FLOOR WHEN THE APPLIANCE IS IN POSITION.
Summary of Installation Procedure
1) Check from the Data Plate, unit is correct for the supply and note the loading for each phase.
2) Fit and connect in conduit a fused isolating switch on the wall convenient to and within easy
reach of the appliance.
3) Remove the cover from the main terminal box situated at the RH side of the cooker back.
4) Measure and prepare cable and flexible conduit to link the terminal box on the appliance to the
isolating switch on the wall. Ensure that it is clear of the floor when fitted.
5) Connect the supply cables to the mains terminal box and make an earth to earth pillar terminal.
6) Fit and secure the cable conduit to an outlet on the connection box and thread the supply cables
through.
7) Connect the cables and flexible conduit to the mains isolating switch and refit the mains
connection box cover.
8) Move the appliance into its working position. Check the level and adjust the feet if necessary.
9) Ensure that any remaining packing and protective covering is removed.
Checking the Operation
ALTHOUGH EVERY APPLIANCE IS TESTED AND SET BEFORE IT LEAVES THE FACTORY, IT IS
IMPORTANT THAT THE INSTALLER RE-CHECKS CERTAIN FUNCTIONS BEFORE LEAVING THE SITE.
1) Ensure that all switches on the appliance are in the “
OFF” position.
2) Turn on the mains isolating switch and check that the green light is “
ON”.
NOTE: - If the appliance has been in store for a prolonged period, particularly if the storage conditions
have been moist, the appliance should be “dried out” before operating at full on.
3) Operate the
ON/OFF switch and note that the interior lamp lights and that the fan motor runs.
4) Set the thermostat to approx. 200°C and note that the oven begins to heat up.
5) Leave to run, ensuring that there is no vibration and that the fan runs smoothly both hot and
cold.
6) Turn the timer “
ON” and allow to run down, ensuring that it rings. (Note: - This is for information
only and does
NOT switch the oven “OFF”.