Owner`s manual

Manual Part No: 930004-01 MD Gas Range - 32 –
Manual Rev No: 1
Service and Maintenance (cont.)
5) To Remove or clean a Hotplate Injector
. (Open Top)
Remove the pan supports.
Remove, by lifting clear, the burner cap, ring, support (skirt) and full width drip shield.
The injector can be unscrewed using a suitable socket spanner.
To clean the injector, brush off with a stiff bristle brush any dirt, blow through the orifice to
remove any blockage or restriction -
DO NOT POKE WIRE THROUGH THE INJECTOR ORIFICE.
6) Servicing and removing a Gas Tap/FFD
.
Remove the control knobs and control panel, which is secured by two fixing screws.
Remove the pan supports.
Remove by lifting clear, the burner cap, ring, support (skirt) and full width drip shield.
The front of the gas tap is now exposed and the procedure for cleaning and re-greasing the tap
can be carried out.
Remove the gas tap from the gas rail by unscrewing the supply tube union connection and
unscrew the single screw in the clamping bracket below the gas tap.
To clean and re-grease a gas tap
: -
Remove the front cover from the gas tap by unscrewing the two Pozi head screws.
Carefully withdraw the cover taking care not to lose the small spring from inside the tap.
Carefully pull the taper plug from the body of the gas tap.
Clean the plug and the inside of the body using a lint-free cloth and a suitable solvent.
Wipe both parts clean and dry. Ensure that all the holes are clean and free from obstruction.
Lightly re-grease the plug using a suitable high temperature grease, such as Rocol, and replace
the plug in the gas tap body.
Lightly grease the inside of the gas tap front cover, position the spring and re-assemble the
front cover to the body.
DO NOT WORK ON MORE THAN ONE TAP AT A TIME.
ENSURE THAT THE PLUG IS PLACED IN THE CORRECT BODY.